Push Pull Toggle Clamps
PP-2
This is a light duty push pull clamp that locks in both the push and pull directions. The handle moves 180 degrees and the plunger travels 3/4". The clamp may be mounted in a tapped hole or with the supplied brass jam nut. The clamps can be used as a lever to pull cable.
Hold Rating: 200 lbs.
PP-3
This is a medium duty clamp that locks in both the push and pull direction. The handle moves 180 degrees and the plunger travels 1 1/2". The clamp can be mounted in a tapped hole or with the supplied zinc jam nut. This is our most popular clamp due to its versatility and strength. The clamp can be used as a lever to pull cable.
Hold Rating: 300 lbs.
PP-3L
This is a medium duty clamp that locks in both the push and pull direction. The handle moves 180 degrees and this L version has a plunger travel of about 2.12". The clamp can be mounted in a tapped hole or with the supplied zinc jam nut. One potential use for this clamp would be as a lever to pull a cable.
Hold Rating: 400 lbs.
PP-3XL
Our new PP-3XL expands our line of PP-3 type clamps. Tis model of the PP-3 boasts 3.00" of travel. The clamp locks in both the plunger extended and plunger retracted position. Minimum 100 piece order is required because this is a custom clamp.
Hold Rating: 300 lbs.
PP-4
A rugged malleable cast iron base makes this clamp stronger than other clamps of this size. The clamp is priced very competitively. We have tested this clamp against punched steel base clamps and found it to be much stronger.
Hold Rating: 600 lbs.
PP-4R
A rugged malleable cast iron base makes this clamp stronger than other clamps of this size. The clamp is priced very competitively. We have tested this clamp against punched steel base clamps and found it to be much stronger. The PP-4R model has the handle mounted in reverse. This change allows the clamp to lock in the plunger retracted position instead of the plunger extended position. The plunger travel is .5" and the clamp only locks in the retracted position.
Hold Rating: 600 lbs.
PP-4-603
This new addition to our line of push pull clamps mounts on the same hole pattern as the De-Sta-Co #603. The clamp is similar to the PP-4 except that the centerline of the clamp above the mounting surface is reduced to .97" to match the #603.
Hold Rating: 600 lbs.
PP-8
This clamp is similar in design to the PP-4 but it has a heavier base and larger diameter plunger. This sturdy compact clamp is our heaviest duty push pull clamp. The plunger travel is 1 1/2" and the plunger is tapped 3/8-16 by 3/4" deep.
Hold Rating: 900 lbs.
PP-8R
This clamp is similar in design to the PP-4 but it has a heavier base and larger diameter plunger. This sturdy compact clamp is our heaviest duty push pull clamp. The plunger is tapped 3/8-16 by 3/4" deep. The PP-8R model has the handle mounted in reverse. This change allows the clamp to lock in the plunger retracted position instead of the plunger extended position. The plunger travel is .5" and the clamp only locks in the retracted position.
Hold Rating: 900 lbs.